Battery Charging; Ac Voltage; Troubleshooting - Bad Boy AMBUSH Owner's Manual

MAINTENANCE
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
In winter conditions, the battery must be fully charged to pre-
vent the possibility of freezing. A fully charged battery will not
freeze in temperatures above -75° F (-60° C). Although the
chemical reaction is slowed in cold temperatures, the battery
must be stored fully charged, and disconnected from any cir-
cuit that could discharge the battery. The controller should be
disconnected from the batteries by setting the Run-Tow/Main-
tenance/Storage switch, located under the passenger seat, to
the 'TOW/MAINTENANCE/STORAGE' position. For portable
chargers, disconnect the charging plug from the vehicle
receptacle. For on-board chargers, disconnect the charging
harness from the batteries. The batteries must be cleaned
and all deposits neutralized and removed from the battery
case to prevent self discharge. The batteries should be tested
or recharged at thirty day minimum intervals.

Battery Charging

5
The battery charger is designed to fully charge the battery set.
If the batteries are severely deep cycled, some automatic bat-
tery chargers contain an electronic module that may not acti-
vate and the battery charger will not function. Automatic
chargers will determine the correct duration of charge to the
battery set and will shut off when the battery set is fully
charged. Always refer to the instructions of the specific char-
ger used.
Before charging, the following should be observed:
Do not overfill batteries. The charging cycle will expel electrolyte and result in component damage.
• The electrolyte level in all cells must be at the recommended level and cover the plates.
• The charging must take place in an area that is well ventilated and capable of removing the hydrogen gas that
is generated by the charging process. A minimum of five air exchanges per hour is recommended.
• The charging connector components must be in good condition and free from dirt or debris.
• The charger connector must be fully inserted into the vehicle receptacle.
• The charger connector/cord set is protected from damage and is located in an area to prevent injury that may
result from personnel running over or tripping over the cord set.
• The charger is automatically turned off during the connect/disconnect cycle and therefore no electrical arc is
generated at the DC plug/receptacle contacts.
In some portable chargers, there will be a rattle present in the body of the charger DC plug. This rattle is caused by an internal mag-
net contained within the charger plug. The magnet is part of the interlock system that prevents the vehicle from being driven when
the charger plug is inserted in the vehicle charging receptacle.

AC Voltage

Battery charger output is directly related to the input voltage. If multiple vehicles are receiving an incomplete charge in a
normally adequate time period, low AC voltage could be the cause and the power company should be consulted.

Troubleshooting

In general, troubleshooting will be done for two distinct reasons. First, a battery that performs poorly and is outside of the
manufacturers specification should be identified in order to replace it under the terms of the manufacturer's warranty. Dif-
ferent manufacturers have different requirements. Consult the battery manufacturer or the manufacturer's representative
for specific requirements.
Page 5 - 14
O O
F C
+15 -9
E
L
+5 -15
E
C
-5 -21
T
R
O
-15 -26
L
Y
-25 -32
T
E
-35 -37
T
-45 -43
E
M
-55 -48
P
E
R -65 -54
A
T
-75 -60
U
R
-85 -65
E
-95 -71
1.140
1.100
1.120 1.160
SPECIFIC GRAVITY ELECTROLYTE FREEZING POINT
1.180 1.220 1.260 1.300
1.200 1.240 1.280