Speco D4CX Operation Instruction Manual page 65

Sequence
Selecting (Sequence) in the Live Monitoring menu causes the cameras to display sequentially. When in one of the
multi-view formats, selecting
the bottom, right screen will display live cameras sequentially (Cameo Sequence). For example, if you select
the 2x2 format, the DVR changes pages as follows:
< Full Sequence >
Selecting again in the Live Monitoring menu exits the Sequence mode. While in the Sequence mode, the
displays in bottom-left corner if Sequence is selected in the Display setup screen (OSD tab). If all the cameras in a page
are Off, or have lost video or are set to Covert (unless the user has authority to view covert cameras), that page will be
excluded from the sequence.
NOTE: The Full Sequence for the full sequence monitoring and the Cameo Sequence for the cameo sequence
monitoring should be selected in the Display setup screen (Main Monitor tab).
Camera Menu
 PTZ: Selecting (Camera Menu) → PTZ and choosing the camera number allows you to control the selected
camera as long as it has Pan, Tilt and Zoom capabilities. Refer to the following PTZ Mode section for details.
 Zoom: Selecting (Camera Menu) → Zoom and choosing the camera number zooms the current image of the
selected camera on the screen. Selecting Zoom again in the Camera Menu again exits the Zoom mode. Refer to
the following Zoom Mode section for details.
 Audio: Selecting (Camera Menu) → Audio toggles audio output On and Off.
 Color Control: Selecting
control brightness, contrast, hue and saturation for each camera for the selected camera if a user who has Color Control
authority logs into the system. It is the same as pressing and holding a camera button for a few seconds.
 Edit Group: Selecting
Active Cameo Mode section for details.
NOTE: It is important that cameras and monitors are correctly installed and adjusted prior to making any image
adjustments using the DVR's controls.
Any image adjustments you make will be applied to both the live video on the monitors and the recorded
video.
The Camera Menu also can be displayed by clicking the right mouse button on the screen while in the
live monitoring mode.
Search
 All Channels: Selecting
It is the same as pressing the
 Triplex: Selecting (Search) → Triplex enters the Triplex mode. Selecting the camera number plays back video
of the selected camera. It is the same as pressing the
Setup
(Setup) in the Live Monitoring menu enters the Main Setup screen. Refer to Chapter 3 ─ Configuration
Selecting
for detailed descriptions of system setup.
Status
Selecting (Status) in the Live Monitoring menu allows you to check the status of the DVR's system, inputs and storage.
Refer to the following Status Monitoring section for details.
NOTE: Selecting Status will only be enabled for a user who has System Check authority.
will cause the DVR to go through predefined screen layouts (Full Sequence). Or,
(Camera Menu) → Color Control and choosing the camera number allows you to
(Camera Menu) → Edit Group enters to the Active Cameo mode. Refer to the following
(Search) → All Channels exits the live monitoring mode and enters the search mode.
button.
PLAY/STOP
PLAY/STOP
Digital Video Recorder
< Cameo Sequence >
button when in one of the multiview formats.
in
icon
57