Compliance Information; Regulatory Information; Declaration Of Conformity - Pace IPH8005 Installation Manual

Compliance Information

This section contains regulatory and compliance information about the receiver.

Regulatory information

CAUTION: Do not attempt to modify your receiver without written authorization from
the manufacturer. Unauthorized modification could void your authority to operate your
receiver.
Trade Name: Pace Americas
Responsible Party: 2Wire, Inc. DBA Pace Americas
Address: 1764 Automation Parkway, San Jose, CA 95131
Phone: (408) 428-9500

Declaration of Conformity

FCC / Industry Canada Compliance
This device has been tested and certified as compliant with the regulations and
guidelines set forth in the Federal Communication Commission - FCC part 15 and
Industry Canada - ICES-003 Radio and telecommunication regulatory requirements /
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Manufacturer: 2Wire, Inc. DBA Pace Americas
Model(s): IPH8005, IPH8010
Part 15 of FCC Rules
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation of the device.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio-frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, you are encouraged to try to correct the interference by one or more of the
following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and the receiver.
•
Connect the equipment to an outlet on a circuit that is different from the circuit used
by the receiver.
•
Consult your dealer or an experienced radio/TV technician for help.
31