Panasonic S-45PU1E5 Technical Data & Service Manual page 343

• Setting mode 2
<Operating procedure>
(1) Press and hold the
4 seconds or longer.
(2) Use the temperature setting
code. The item codes and setting data are shown in the table below.
(3) Use the timer time
To confi rm the changed setting data, press the
(At this time, "Setting" stops blinking and remains lit.)
(4) During this mode, "Setting" is displayed, blinking. The display shows the set
outdoor unit address "System XX-YY" (System XX = System address, YY =
Address at outdoor unit sub-bus), item code number (DN value in the table
below), and the setting data (6 digits).
(The setting data is displayed in 6 digits. The display changes between the fi rst 3 digits (Fig. A ) and the last 3
digits (Fig. B ). When the fi rst 3 digits are displayed, the top point of the colon is lit.)
(5) To end the setting mode, press the
A
(5)
80: <Refrigerant type> A and B are displayed alternately. (Example shows 000 410 (R410A).)
List of Item Codes
Item code
80 Refi gerant typer
81 Outdoor unit capacity*
82 Control system schedule
83 Control system schedule
84 3-phase or single-phase
85 Power frequency
86 Control system schedule
87 Control system schedule
88 Control system schedule
89 Control system schedule
8A Control system schedule
8b Control system schedule
8E Control temp. for outdoor
Upward fan fan's crack prevention
model only
available
button, button, and
and buttons to change the item
and buttons to change the setting data.
button. The display returns to the normal display mode.
Display of fi rst 3 digits
(2)
(1) (3)
407 = R407C 22 = R22 410 = R410A
0 = Disabled 22 25 28 32 36 40
90 100 112 125 140 160 180 200 224 250 280 340
355 400 450 500 560 600 630 670 710 800 840
Do not set
Do not set
0 = 3-phase 1 = single-phase
0 = Disabled 1 = 50Hz
Do not set
Do not set
Do not set
Do not set
Do not set
Do not set
Setting temperature range : -125 ~ +125
Crack prevention of outdoor fan actuates when the outdoor temp.
reaches lower than the setting values.
button simultaneously for
button.
Display of last 3 digits
B
Parameter
(*) Figures represent the capacity data for each model.
6-9
(5)
(1) (3)
45 50 56 63 71 80
(2)
6