Receiver/Gyro Installation - THUNDER TIGER Raptor 30 V2 User Manual

17 Servo Installation-Part2
Assembly Tip: Remove all the servo wheels prior to attaching the steel linkage
balls. Make sure all linkages are the correct length.
(1) HSE2612N Self Tapping Screw(M2.6x12).... 8
(2) HMF2-8N Screw(M2x8)................................ 3
(3) HML2 Hex Nut(M2)...................................... 3
(4) BK0075 Linkage Ball.................................... 3
(5) BK0094 Linkage Rod .................................. 1
(6) BK0092 Linkage Rod .................................. 1
(7) BK0086 Ball Link.......................................... 4
52mm
(1) HSE2612N
Throttle Servo

18 Receiver/Gyro Installation

Thunder Tiger recognizes that there are many brands of radios and gyros to choose from. You are encouraged to
seek the advice of experienced helicopter pilots when making this decision. We do recommend the use of the Thunder
Tiger TG-8000 piezo Gyro since it was designed expressly for this machine.
(1) BE1052 Antenna Tube................... 1
(2) BK0106 Double Side Tape............ 2
Thunder Tiger TG-8000 piezo
gyro is recommended
(2) BK0106
(1) BE1052
Pitch Servo
(7) BK0086
(6) BK0092
(3) HML2
(4) BK0075
(2) HMF2-8N
(1) HSE2612N
(3) HML2
(4) BK0075
(2) HMF2-8N
Mount the Steel Link
Ball at 10.5mm(approx
7/16") from the center
of the servo horn.
(1) HSE2612N
On/Off Switch Face Plate
15
(3) HML2
(4) BK0075
(2) HMF2-8N
(7) BK0086
(5) BK0094
75mm
On/Off Switch
Gyro Amplifier
(2) BK0106
Receiver
(2) BK0106
Battery Pack
(2) BK0106