Table of Contents
Advertisement
3.
Select and prepare the installation location
In order to prevent potential dangers and prolong the service life of the
display, please observe the following points when installing, operating and
cleaning the display.
Do NOT place the display on an
uneven, sloping or unstable
surface where it may fall and
cause damage to itself or others.
Have a qualified technician
secure the display where it is
placed in case there is an
earthquake.
Do NOT place the display near
water, like a spa or pool, or in a
position which will allow the
splashing or spraying of water
onto the display, like in front of
an open window where rain
water may enter.
Do NOT place the display near
or above sources of heat, such as
radiators, heaters, fuel stoves and
other heat-generating items
(including audio amplifiers).
Otherwise heat may cause
damages to the outer casing as
well as the components inside.
If wall mounting, allow
appropriate space on top for
attaching the display to the wall
bracket.
If wall mounting, have a suitable
qualified and experienced
tradesperson mount it safely. Use
only a recommended display wall
bracket for this model display
and ensure that the mounting
bracket (optional accessory) is
securely screw fixed to the wall
structure, and not just the wall
render, lining or cladding.
Ensure the bracket is level
horizontally. Do not glue the
bracket to the wall.
Do NOT place the display in an
enclosed place without allowing
for ventilation.
All Liquid Crystal Display (LCD)
screens have a very thin protective
layer of glass which is liable to
marking or scratching, and
cracking if struck or pressured.
The liquid crystal substrate is also
liable to damage under excessive
force or extreme temperatures.
Please handle with care.
Do NOT cover or block the vents
and openings while the display is
switched on, as the heat may
accumulate inside the display
and result in danger.
Do NOT place the display in
direct sun or where direct sun or
spot lighting will shine onto the
display, as the heat may damage
the display and the bright light
will make viewing the display
more difficult than necessary.
If recessed into a wall opening, you
must leave appropriate free space
around the display for proper
dissipation of heat.
This display has no power
switch. When installing the
display, incorporate a readily
accessible disconnect device in
the fixed wiring, or connect the
power cord to socket-outlet
which must be provided near the
display and easily accessible. If a
fault should occur during
operation of the unit, operate the
disconnect device to switch the
power supply off, or disconnect
the power cord.
Observe all warnings and
cautions as labelled on the
display.
Section 1: Quick Start Guide
3
Advertisement
Table of Contents
