Table of Contents
Advertisement
7. Connect the power cable
1. Locate the power cable from the packaging, and plug the appropriate end
into the
AC-INLET
2. Plug the other end into an appropriate wall power outlet, and turn on the
switch (if the power outlet is switched). The display will enter standby
mode and the power indicator (on the front lower right) will light up red.
AC-INLET
Power
outlet
Power cable
• The supplied power cable is suitable for 110V AC power only.
• The type of power cable plug and socket illustrated may differ from the type
used in your region.
• Only use an appropriate power cable for your region. Never use a power cable
which appears damaged or frayed.
• Never change the plug type on a power cable. Be aware of total loading when
using extension cords or multiple outlet power boards.
• This display has no power switch. When installing the display, incorporate a
readily accessible disconnect device in the fixed wiring, or connect the power
cord to socket-outlet which must be provided near the display and easily
accessible. If a fault should occur during operation of the unit, operate the
disconnect device to switch the power supply off, or disconnect the power cord.
WARNING: This display has been engineered and manufactured with the highest
priority on safety, however, IMPROPER HANDLING OR USE CAN RESULT IN
POTENTIAL ELECTRICAL SHOCK OR FIRE HAZARD. Please handle this display
with care. If damaged, turn off the power and unplug the power cable from the
display. Transport the display to your nearest BenQ authorised service centre for
repair.
8. Adjust the viewing angle
This display is equipped with an adjustable
swivel base. If necessary, turn the display
screen to an appropriate angle for more
comfortable viewing.
The maximum angle of rotation (left and right):
• VB2621: 15 degrees
• VB3222 / VB3223E: 30 degrees
14
Section 1: Quick Start Guide
socket on the rear of the display (as illustrated below).
socket
Advertisement
Table of Contents
