Table of Contents
Advertisement
26,000 Stu/Hr Units
lTt
10,000 Btu/Hr Units
we>
vsPa•4
er
)
so
I
. s . r .
imik. 24
111/L111.1110 ,
Figure 59 - Incorrect Burner Flame Pattern
INSPECTING BURNERS
Pilot Flame Pattern
Burner Flame Pattern
INSPECTING BURNERS
Check pilot flame pattern and burner flame patterns often
BURNER FLAME PATTERN
PILOT FLAME PATTERN
Figure 56 shows a correct pilot flame pattern. Figure 57 shows an
incorrect pilot flame pattern. The incorrect pilot flame is not
touching the thermocouple. This will cause the thermocouple to
cool. When the thermocouple cools, the fireplace will shut down.
If pilot flame pattern is incorrect, as shown in Figure 57
•
turn fireplace off (see
To
Turn
Off
Gas to Appliance,
page 24 for Ther-
mostat-Controlled Models or page 25 for Remote-Ready Models)
• see Troubleshooting,
pages 30 through 32
Note:
The pilot flame on natural gas units will have a slight curve,
but flame should be blue and have no yellow or orange color.
Thermocouple
Figure 56 - Correct Pilot Flame Pattern (Propane/LP Remote-
Ready Shown)
Thermocouple
Figure 57- Incorrect Pilot Flame Pattern (Propane/LP Remote-
Ready Shown)
Figure 5S shows a correct burner flame pattern. Figure 59 shows an
incorrect burner flame pattern. The incorrect burner flame pattern
shows sporadic. irregular flame tipping. The flame should not be
dark or have an orange/reddish tinge.
Note:
When using the fireplace the first time, the flame will be
orange for approximately one hour until the log cures.
If burner flame pattern is incorrect, as shown in Figure 59
•
turn fireplace otl(see
To TW710ffGas
to Appliance,
page 24 for Ther-
mostat-Controlled Models or page
25
for Remote-Ready Models)
•
see
Troubleshooting,
pages 30 through 32
26,000 Btu/Hr Units
10,000 Btu/Hr Units
l
ir
1
a
--
..L..siaiesi
Figure 58- Correct Burner Flame Pattern
For more informationt'
4.1 r
r - IJJJJ
107032-0IJ
Advertisement
Table of Contents
