Desa M42E Installation Manual
Desa owner's operation and installation manual b-vent decorative gas fireplace m36e(b,h), m42e(b,h), vm36e(b,h), vm42e(b,h)
Hide thumbs
Also See for M42E:
- Owner's operation and installation manual (28 pages) ,
- Owner's operation and installation manual (32 pages)
Table of Contents
Advertisement
Quick Links
For more information, visit www.desatech.com
For more information, visit www.desatech.com
MODELS M36E(B,H), M42E(B,H), VM36E(B,H) AND VM42E(B,H)
ELECTRONIC IGNITION - NATURAL GAS
WARNING: If the information in these instruc-
tions is not followed exactly, a fire or explosion
may result causing property damage, personal
injury or death.
FOR YOUR SAFETY
— Do not store or use gasoline or any other flam-
mable vapors or liquids in the vicinity of this or
any other appliance.
— WHAT TO DO IF YOU SMELL GAS :
• Do not try to light any appliance.
• Do not touch any electrical switch;
• Do not use any phone in your building.
• Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
• If you cannot reach your gas supplier, call the
fire department.
— Installation and service must be performed by a
qualified installer, service agency, or the gas
supplier.
This appliance may be installed in an aftermarket* manufactured (mobile) home, where not prohibited by state
or local codes.
This appliance is only for use with the type of gas indicated on the rating plate.
This appliance is not convertible for use with other gases, unless a certified kit is used.
*Aftermarket: Completion of sale, not for purpose of resale, from the manufacturer.
B-VENT DECORATIVE GAS FIREPLACE
OWNER'S OPERATION AND
TM
INSTALLATION MANUAL
Save this manual for future reference.
Save this manual for future reference.
SAVE THIS MANUAL
This manual is valuable. In addition to instruct-
ing you on how to install and maintain your
appliance, it also contains information that will
enable you to obtain replacement parts or
optional accessory items when needed. Keep
it with your other important papers.
WARNING: Improper installation, ad-
justment, alteration, service or main-
tenance can cause injury or property
damage. Refer to this manual. For
assistance or additional information
consult a qualified installer, service
agency, or the gas supplier.
NOT FOR USE WITH SOLID FUEL
CHECK LOCAL CODES PRIOR TO
INSTALLATION
MASSACHUSETTS STATE CODE
REQUIRES THE VENT DAMPER TO
BE WELDED OPEN OR REMOVED.
Advertisement
Table of Contents
Related Manuals for Desa M42E
Summary of Contents for Desa M42E
- Page 1 For more information, visit www.desatech.com For more information, visit www.desatech.com MODELS M36E(B,H), M42E(B,H), VM36E(B,H) AND VM42E(B,H) ELECTRONIC IGNITION - NATURAL GAS WARNING: If the information in these instruc- tions is not followed exactly, a fire or explosion may result causing property damage, personal injury or death.
-
Page 2: Table Of Contents
TABLE OF CONTENTS SAFETY INFORMATION TABLE OF CONTENTS SAFETY INFORMATION ... 2 UNPACKING ... 3 INTRODUCTION ... 4 PRODUCT SPECIFICATIONS ... 5 SELECTING LOCATION ... 6 PRE-INSTALLATION PREPARATION ... 6 VENTING INSTALLATION ... 9 INSTALLATION ... 11 OPERATING FIREPLACE ... 17 INSPECTING BURNERS ... -
Page 3: Unpacking
SAFETY INFORMATION Continued Turn fireplace off and let cool before servicing or repairing. Only a qualified service person should install, service, or re- pair this fireplace. Have fireplace inspected annually by a quali- fied service person. You must keep control compartments, burners, and circulating air passages clean. -
Page 4: Introduction
: A) Modification of the appliance or any of the components. B) Use of any component part not approved by DESA in combi- nation with this appliance. C) Installation and/or operation in a manner other than instructed in this manual. -
Page 5: Product Specifications
PRODUCT SPECIFICATIONS For Use With 6"Ø Type B-1 Vent Pipe Only Stand Off Collar 7" 7" Outside Air Kit Location (Optional) Model 36 29" 5/8" 41" 12" " " (24" w/o Brick) " (34" w/o Brick) " (16 " w/o Brick) "... -
Page 6: Selecting Location
SELECTING LOCATION PRE-INSTALLATION PREPARATION Clearances SELECTING LOCATION To determine the safest and most efficient location for your appli- ance, you must take into consideration the following guidelines: The location must allow for proper clearances (see Clearances, next column). Consider a location where heat output would not be affected by drafts, air conditioning ducts, windows, or doors. - Page 7 12" (229mm) 6" (152mm) 3" (76mm) " (38mm) Max. M36E(B,H) M42E(B,H) VM36E(B,H) VM42E(B,H) 14" (356mm) 15" (381mm) 8" (203mm) 9" (229mm) Figure 5 - Mantel Clearances - Side View (Cross Section) For more information, visit www.desatech.com For more information, visit www.desatech.com...
- Page 8 (five used on the model M42). To install B-vent piping, slide the first piece of B-vent over the transition pipe and attach with a minimum of two screws. M42E(B,H) VM42E(B,H) " (1121mm) " (587mm) "...
-
Page 9: Venting Installation
VENTING INSTALLATION A B-type venting system must be connected to the appliance for venting to the outside of the building. The following section is provided as a guide to a standard B-type vent installation. Standing codes requirements concerning B-type vent installations may vary within your state, province or local codes jurisdiction. - Page 10 VENTING INSTALLATION Checking for Proper Venting VENTING INSTALLATION Continued Vent terminations must be located in accordance with height and proximity rules of NFPA No. 54 or CAN/CGA B149. These rules apply to vents at 12 in. diameter or less and require a minimum height in accordance with the roof pitch and a minimum of 8 ft.
-
Page 11: Installation
Handset Typical Exterior Wall Gas Shutoff Installation 1/2" NPT Incoming Alternate Gas Supply Through Sub-Floor Black Iron Gas Line 7" 7" M36E(B,H) M42E(B,H) VM36E(B,H) VM42E(B,H) " (219mm) " (267mm) 11" (279mm) " (324mm) Pull to Remove Insulation Tab Shutoff Valve... - Page 12 Ember and Pan Material Placement INSTALLATION Continued DESA recommends that a black iron gas line be routed from the gas source, through a sediment trap (shown in Figure 18), and into the appliance, Once connected through the appliance, a flexible gas line may be used for ease of installation to gas control valve (see Figure19).
- Page 13 INSTALLATION Continued LOG PLACEMENT FOR M36E/VM36E MODELS Place small front right log (log 1) on right front of grate as shown in Figure 23. Place large back log (log 2) onto grate making sure notches rest over grate as shown in Figure 23. Place log 3 across logs 1 and 2 aligning pegs on log 3 with holes in logs 1 and 2 (see Figure 24).
- Page 14 Log 1A Figure 28 - Installing Logs 3 and 4 Log 2 Figure 29 - Installing Logs 5 and 6 Log 1B Figure 30 - Logs Installed for M42E/VM42E Models Log 4 Log 2 Log 1B Log 5 Log 6...
- Page 15 Note: Glass door may be heavy for some individuals. If this is the case, please request help from someone else. The M36E, VM36E, M42E and VM42E B-vent fireplaces are approved for use with optional bi-fold glass doors (see Accessories, page 25). The glass panels may be ordered and installed anytime after the fireplace installation is complete.
- Page 16 INSTALLATION Installing Optional Glass Door Accessory (Cont.) Opening Vent Damper INSTALLATION Continued Once the top and bottom pins are secured, unfold the door into the closed position. Repeat the process for the opposite door assembly. To adjust the doors, slide them partially open. Using a screw- driver, loosen the hold-down screws in the spring clip (see Fig- ure 34) and pivot plate.
-
Page 17: Operating Fireplace
OPERATING FIREPLACE FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing prop- erty damage, personal injury or loss of life. A. This appliance is equipped with an ignition device which automatically lights the pilot. -
Page 18: Inspecting Burners
INSPECTING BURNERS Pilot Assembly Burner Flame Pattern CLEANING AND MAINTENANCE Pilot and Burner Logs INSPECTING BURNERS Check pilot flame pattern and burner flame patterns often. PILOT ASSEMBLY The pilot assembly is factory preset for the proper flame. Alterations may have occurred during shipping and handling. The pilot is located on the back right hand side of the burner. -
Page 19: Service Hints
TECHNICAL SERVICE You may have further questions about installation, operation, or troubleshooting. If so, contact DESA International’s Technical Ser- vice Department at 1-866-672-6040. You can also visit DESA International’s Technical Services web site at www.desatech.com. WIRING DIAGRAM Pilot Burner... -
Page 20: Troubleshooting
TROUBLESHOOTING TROUBLESHOOTING Note: For additional help, visit DESA International’s technical service web site at www.desatech.com. Note: Before troubleshooting the system, make sure the gas shutoff valve is ON. OBSERVED PROBLEM Ignitor will not spark or pilot will not light Pilot will not stay lit... - Page 21 TROUBLESHOOTING Continued WARNING: If you smell gas • Shut off gas supply. • Do not try to light any appliance. • Do not touch any electrical switch; do not use any phone in your building. • Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
-
Page 22: Illustrated Parts Breakdown
ILLUSTRATED PARTS BREAKDOWN M36E(B,H),M42E(B,H), VM36E(B,H) AND VM42E(B,H) Models ILLUSTRATED PARTS BREAKDOWN M36E(B,H),M42E(B,H), VM36E(B,H) AND VM42E(B,H) MODELS For more information, visit www.desatech.com For more information, visit www.desatech.com 37(LP) 35 34 59/60 108796... -
Page 23: Parts List
For more information, visit www.desatech.com For more information, visit www.desatech.com 108796 M36E(B,H),M42E(B,H), VM36E(B,H) AND VM42E(B,H) Models This list contains replaceable parts used in your heater. When ordering parts, follow the instructions listed under Replacement Parts on page 19 of this manual. - Page 24 ILLUSTRATED PARTS BREAKDOWN Logs for M36E(B,H),M42E(B,H), VM36E(B,H) and VM42E(B,H) Models ILLUSTRATED PARTS BREAKDOWN LOGS FOR M36E(B,H),M42E(B,H), VM36E(B,H) AND VM42E(B,H) MODELS Logset for M36E(B,H) and VM36E(B,H) Models PART NUMBER DESCRIPTION 107999-01 Log Set 108724-01 Right Front 9" Split Log 901098-01 Rear Log...
-
Page 25: Accessories
Purchase these firebox accessories from your local dealer. If they can not supply these accessories, call DESA International’s Sales Department at 1-866-672-6040 for information. You can also write to the address listed on the back page of this manual. -
Page 26: Warranty Information
LIMITED WARRANTY B-VENT FIREPLACE DESA International warrants this product to be free from defects in materials and components for four (4) years from the date of first purchase, provided that the product has been properly installed, operated and maintained in accordance with all applicable instructions. To make a claim under this warranty the Bill of Sale or cancelled check must be presented.