Bdo; Bfb; Bim - AMX MIO-R4 Instruction Manual

"^" Button Commands (Cont.)

^BDO

Set the button draw order
Syntax:
Variable:
• variable text address range = 1 - 4000.
• button states range = 1 - 256 for multi-state buttons (0 = All states, for General buttons 1 = Off state and
• layer assignments = Fill Layer
Example:
Sets the button's variable text 530 ON/OFF state draw order (from bottom to top) to Border, Fill, Text, Icon, and
Image.
Example 2:
Sets all states of a button back to its default drawing order.

^BFB

Set the feedback type of the button. ONLY works on General-type buttons.
Syntax:
Variables:
• variable text address range = 1 - 4000.
• feedback type = (None, Channel, Invert, On (Always on), Momentary, and Blink).
Example:
Sets the Feedback type of the button to 'Momentary'.

^BIM

Set the input mask for the specified address.
Syntax:
Variable:
• variable text address range = 1 - 4000.
• input mask = Refer to the Input Commands section on page 65 for character types.
Example:
Sets the input mask to ten 'A' characters, that are required, to either a letter or digit (entry is required).
Mio Modero R-4 Remote
"'^BDO-<vt addr range>,<button states range>,<1-5><1-5><1-5><1-5><1-5>'"
2 = On state).
Image Layer = 2
Icon Layer
Text Layer
Border Layer = 5
Note: The layer assignments are from bottom to top. The default draw order is 12345.
SEND_COMMAND Device,"'^BDO-530,1&2,51432'"
SEND_COMMAND Device,"'^BDO-1,0,12345'"
"'^BFB-<vt addr range>,<feedback type>'"
SEND_COMMAND Remote,"'^BFB-500,Momentary'"
"'^BIM-<vt addr range>,<input mask>'"
SEND_COMMAND Device,"'^BIM-500,AAAAAAAAAA'"
= 1
= 3
= 4
Programming the Mio R-4
45