Installation Requirements; Tools And Parts - Whirlpool WASHER Installation Instructions Manual

Gather the required tools and parts before starting installation.
The parts supplied are in the washer basket.
Tools needed for connecting the drain hose and water
inlet hoses:
Pliers that open to
3.95 cm (1⁹⁄₁₆")
Parts supplied:
B
A
E
A. Water inlet hoses (2)
B. Drain hose form
C. Drain hose extension
D. Drain hose coupling
Tools needed for securing the drain hose and leveling
the washer:
Adjustable or open end
wrench 14 mm (⁹⁄₁₆")
Level
Parts supplied:
A
A. Beaded tie strap
B. Front leveling feet with nuts (2)
2

INSTALLATION REQUIREMENTS

Flashlight (optional)
C D
F G
E. Large flat washers (4)
F. Small flat washers (2)
G. Inlet hose adapter
H. Hose clamp (2)
Wood block
Ruler or measuring tape
B

Tools and Parts

Alternate Parts
Your installation may require additional parts. For ordering
information, please refer to the toll free phone numbers on the
front page of the Washer User Instructions.
If You Have:
Laundry tub or
standpipe taller
than 2.4 m (96")
Overhead sewer
Floor drain
H
Water faucets
beyond reach of fill
hoses
Drain hose too
short
Drain hose that is
too long
Lint clogged drain
You Will Need to Buy:
Sump pump system (if not already
available)
Standard 76 L (20 gal.) 99 cm (39") tall
drain tub or utility sink, sump pump and
connectors (available from local
plumbing suppliers)
Siphon break, Part Number 285320;
additional drain hose,
Part Number 3357090 and connector kit,
Part Number 285442
2 longer water fill hoses:
1.8 m (6 ft) Part Number 76314,
3.0 m (10 ft) Part Number 350008
Drain hose, Part Number 388423 and
hose kit, Part Number 285442
Hose kit, Part Number 285442
Drain protector, Part Number 367031