Timer-To-Close (Ttc) - Chamberlain LiftMaster MJ5011U Installation Manual

BASIC PROGRAMMING
REMOTE CONTROLS
To prevent possible SEVERE INJURY or DEATH:
• Install a LiftMaster Monitored Entrapment Protection (LMEP)
device.
• NEVER permit children to operate or play with door control
push buttons or remote controls.
Built in 315 MHz radio receiver permits as many as 20 Security✚
SINGLE BUTTON REMOTE CONTROL
1
Repeat steps 1 and 2 for additional remote controls.
3-BUTTON REMOTE CONTROL TO OPERATE AS A WIRELESS 3-BUTTON CONTROL STATION
NOTE: The feature will use 3 of the 20 memory channels in the operator.
1
Repeat steps 1 through 3 to program additional buttons.

TIMER-TO-CLOSE (TTC)

Timer-to-Close feature enables the operator to close from the open limit after a preset time, adjustable from 5 to 60 seconds. Requires
LiftMaster Monitored Entrapment Protection (LMEP) device.
TO PROGRAM
Begin with door in fully closed position.
1
The TTC will become active after completion of the next open cycle. NOTE: The LED does not indicate that timer is running.
TO VERIFY TIMER-TO-CLOSE (TTC) SETTING
1
Press and hold the button on the remote control
2
until the LED fl ashes rapidly, then release to
complete programming (LED will go out).
Press and release
the LEARN button
(LED will light).
AVERTISSEMENT
2
Press and hold
the LEARN button
(LED will light).
2
Press and
release the
LEARN button
(LED will light).
2
Press and hold
the LEARN button
(LED will light).
WARNING WARNING
• Activate door ONLY when it can be seen clearly, is properly
CAUTION
adjusted and there are no obstructions to door travel.
• ALWAYS keep door in sight until completely closed. NEVER
permit anyone to cross the path of closing door.
® remote controls or dip switch remote controls in any combination.
ATTENTION
3
Press the desired
button on the logic
board (OPEN,
CLOSE or STOP).
Release both
buttons.
3
ADVERTENCIA
Press and
release the
TTC button.
PRECAUCIÓN
Press and
release the
TTC button.
22
TO ERASE ALL REMOTE CONTROLS
1
Press and hold the desired button of the remote
control until LED fl ashes rapidly, then release.
4
Every press and release
of the STOP button
will add 5 seconds to
the Timer-to-Close.
Example: 30 second
TTC = 6 presses of the
STOP button.
3
Press and release the TTC button a
second time. The LED will fl ash once
per 5 seconds of timer setting.
Press and hold the
LEARN button (over 5
seconds) until the
LED goes out. All
programmed remote
controls will be
erased.
AVE
AV
AD
Press and release
the TTC button to
exit programming
mode. The LED
A
will fl ash once per
5 seconds of timer
setting.