Page 1
Instructions – Garage Door Operator Model ML700-GB, ML750-GB and ML850-GB WARNING: DAMAGE MAY OCCUR TO DOOR OR OPERATOR IF IR PROTECTOR SYSTEM IS NOT INSTALLED. PROTECTOR SYSTEM MUST BE INSTALLED FOR PROPER FUNCTIONING OF THE OPENER. SEE PROTECTOR SYSTEM INSTALLATION STEPS.
Page 2
Door Types One-Piece Door with Horizontal Track Only. One-Piece Door with Horizontal and Vertical Track – Special door arm (E, The Chamberlain Arm™) and the Protector System™ (29 (8)) required. See your dealer. Sectional Door with Curved Track – See 20B – connect door arm. The Protector System™ (29 (8)) is required for doors that are over 2.5m in height.
IMPORTANT: If you have a canopy door, you need to use the To avoid serious personal injury from entanglement, remove all instructions packed with The Chamberlain Arm™ Accessory in ropes connected to the garage door before installing the opener. conjunction with this Owner's Manual when assembling the rail.
Page 4
Connect Electric Power Install the Header Bracket TO AVOID INSTALLATION DIFFICULTIES, DO NOT RUN THE NOTE: Refer to vertical center and horizontal lines created in step GARAGE DOOR OPENER UNTIL INSTRUCTED TO DO SO. 12 for proper placement of header bracket. Connect the door opener only to an outlet controlled by a double A.
Page 5
Install Door Control Install the Protector System™ Locate door control where the garage door is visible, away from In order to operate this unit, the Protector System™ MUST be door and door hardware and out of the reach of children. Mount installed.
Page 6
Aligning the Safety Sensors Program your Opener & Remote Plug in opener. Indicator lights in both sending and receiving eyes Activate the opener only when door is in full view, free of will glow steadily if wiring connections and alignment are correct. obstruction and properly adjusted.
ADJUSTMENT SECTION Program your Keyless Entry Setting the Limits Activate the opener only when door is in full view, free of obstruction and properly adjusted. No one should enter or leave Travel limits regulate the points at which the door will stop when garage while door is in motion.
Page 8
Model 41EML 2-Position Key Switch (Surface Mount) Figure D: Canopy and one-piece door with horizontal and vertical track with “The Chamberlain Arm” installed NOT SHOWN Model MDL100EML Mechanical Door Latch Kit Locate the Quick Release on the outside of your garage door (2).
HAVING A PROBLEM? 12. Opener strains: 1. Opener doesn't operate from either door control or remote: Door may be unbalanced or springs are broken. Close door and use • Does the opener have electric power? Plug lamp into outlet. If it manual release rope and handle to disconnect trolley.
CARE OF YOUR OPENER OPERATION OF YOUR OPENER When properly installed, opener will provide high performance with Your opener can be activated by any of the following devices: a minimum of maintenance. The opener does not require additional • The Lighted Door Control Button. Hold the button down until door lubrication.
Input Voltage....230-240 VAC, 50Hz Max. Pull Force ....700N (ML700-GB, ML750-GB) ........800N (ML850-GB) Power ......115W (ML700-GB, ML750-GB) ........125 (ML850-GB) Standby-by power rating @ 230V..5.5W (ML700-GB, ML750-GB, ML850-GB) Normal Torque ....7Nm (ML700-GB, ML750-GB) ........8Nm (ML850-GB) Motor Type ........DC gearmotor permanent lubrication Drive Mechanism Drive .......Chain/belt with two-piece trolley on...
Page 12
This warranty does not cover non-defect damage caused by unreasonable use (including use All technical file information for the operator and its accessories is held at The Chamberlain Group and not in complete accordance with Chamberlain’s instructions for installation, operation and will be made available at the request of the authorities should the need arise.
Page 13
Illustrations – Garage Door Operator Model ML700-GB, ML750-GB and ML850-GB 0800 317847 114A2884D...
Page 14
10 mm, 8 mm, 4,5 mm, 4 mm 11mm, 13mm 114A2884D...