Feet - HP 100B Maintenance & Serice Manual

Feet

Description
Foot, right
Foot, left
Each foot is connected to the computer with one screw. The top of the foot is positioned under the
display panel bracket. You must slide the foot out from under the bracket to remove it, and place it
back under the bracket to install it.
To remove the feet:
1. Prepare the computer for disassembly (see
on page
2. Remove the rear cover (see
3. For each foot, remove the Torx T15 3.0x6.0 screw (1) that secures the foot to the computer.
4. Slide the foot away out from under the display panel bracket and away from the computer (2).
Figure 6-5
To replace the feet, reverse the removal procedures.
When reinstalling a foot, make sure you slide the top of the foot under the display panel bracket
before securing the screw.
30 Chapter 6 Removal and Replacement Procedures All-in One (AIO) Chassis
26).
Rear Cover on page
Removing the feet (right foot shown)
Preparing to Disassemble the Computer
27).
Spare part number
646784-001
646785-001