When the switch «2» is set to «A», the following are always activated: tail lights, in-
strument panel lights and low-beam light. If it is set to «B», the high-beam light is
activated.
If the light switch «2» is pressed when set to «C», the high-beam light flashes.
01_11
Start-up button (01_12)
By pressing the starter button «2» and operating a brake lever (front or rear) at the
same time, the starter motor spins the engine.
NOTE
ELECTRICAL COMPONENTS FUNCTION ONLY WHEN THE IGNITION KEY IS
SET TO "ON"
01_12
Engine stop button (01_13)
(countries where required)
22