Panasonic WV-SW396A Installation Manual page 20

Installation
Before starting installation/connection, make sure that the power cable is not connected to the main power supply.
Refer to the "Precautions for installation" section before starting installation/connection. (☞ Page 13)
Step 1
Install the mounting bracket.
When using the wall mount bracket WV-Q122A
(option).
Refer to the installation guide of the bracket (WV-Q122A)
for details on the installation procedure.
Take care of the direction to install the mount bracket so
that the camera can be mounted at the front of the
bracket.
When using the mount bracket (locally procured).
The figure shows an example of the camera mounted on
a ceiling with a locally procured bracket.
Refer to the instructions included with the bracket for fill-
ing gaps and holes with waterproof material.
Construction
Procure a ceiling mount bracket.
R 1-1/2, 11crest, deep 30 MAX
(taper pipe thread)
RP 1-1/2, 11 crest,
deep 30 MAX
(parallel pipe thread)
(60 mm {2-3/8 inches})
20
25 mm {1 inches}
85 mm {3-11/32 inch
Mounting the Bracket
q Fix the bracket to the installation surface using appro-
priate bolts, nuts or the like (not supplied).
w Fix the attachment pipe to the bracket.
e Fill the gap between the bracket and attachment pipe
with waterproof material such as silicon clay.
Step 2
Connect the cables to the camera.
Refer to page 24 for how to connect the cables.
Step 3
Insert the SDHC/SD memory card into the SDHC/SD
memory card slot.
Refer to page 16 for how to insert the SDHC/SD memory
card.
Attachment pipe
Waterproof material
Housing base