Table of Contents
Advertisement
Before you store the air compressor, make sure you do the following:
1.
Review the "Maintenance" section on the preceding pages and perform
scheduled maintenance as necessary.
2.
Set the On/Auto/Off lever to "OFF".
3.
Close the globe valve.
4.
Remove the air tool or accessory.
5.
Open the globe valve and allow the air to slowly bleed from the air tank
until tank pressure is approximately 20 psi.
6.
Drain water from air tank by opening drain valve (counter-clockwise) on
bottom of tank.
tank rupture.
7.
After the water has been drained, close the drain valve.
NOTE: If drain valve is plugged, release all air pressure. The valve can then be
removed, cleaned, then reinstalled.
8.
Protect the air hose from damage (such as being stepped on or run over).
STORAGE
Water will condense in the air tank. If not drained, water
will corrode and weaken the air tank causing a risk of air
21- ENG
D24225
Hide quick links:
Advertisement
Table of Contents
