Settings And Connections - Pacific Digital PDCdrive Installation Manual

Settings and Connections

Connection example
Most computer motherboards have two IDE interface connectors: a Primary and a
Secondary.
You can connect a total of four units to the motherboard: one Master and one
Slave IDE unit to the Primary and Secondary connector.
We recommend connecting the PDC drive as Secondary Master.
NOTE: This unit is set as a Master at the time of shipment.
NOTE: Some Compaq, HP, or Dell computers use Cable Select which is
the third set of jumpers on the left side. Please refer to your Computer
Manual if you have one of these types of computers.
Caution:
Do not mount the jumper pin sideways or in any position other
than specified. This can cause the unit to malfunction.
9
NOT allowed