Table of Contents
Advertisement
IDE / ATAPI Drive Installation
Step 1:
Unpack the drive and contents. Included is a PDC Burner Bundle
software disc, one blank CD-R disc, an audio cable and the IDE data
cable. NOTE: Keep your Pacific Digital CD-RW drive in it's Anti-Static
bag until Step 7.
Step 2:
Record your drive information on page 18 of this manual.
Step 3:
Shut down and turn off the computer.
Step 4:
Remove the cover from the computer. Please refer to the your PC owner's
manual for the proper way to do this.
Step 5:
Remove the cover plate from an available 5.25" drive bay or remove the
drive that you want to replace. Set aside any mounting hardware for later
use.
Step 6:
Set the Master/Slave/CableSelect jumper as appropriate for your system.
Refer to page 9 on setting the Master/Slave/CableSelect settings.
Step 7:
Remove your drive from the Anti-Static bag and slide drive into bay and
secure properly. Refer to the page 10 for directions on mounting your
drive (Mounting hardware is not included).
8
Advertisement
Table of Contents
