Table of Contents
Advertisement
Handling Guidelines Continued
Step 2:
Once the disc tray has fully extended, place the CD-ROM, CD-R or CD-
RW disc into the center of the tray. Press the eject button to have the drive
accept the CD-ROM, CD-R or CD-RW disc.
Step 3:
The busy lamp will light for a few seconds to indicate that a disc has been
loaded and the drive has accepted the disc.
Step 4:
To eject and insert the disc, press the EJECT button.
Note:
Some software prohibits the use of the EJECT button, so a disc
cannot be ejected this way. Please refer to the instructions supplied with
your software.
Note:
The disc cannot be ejected while the drive is reading or writing a
disc.
Step 5:
Once it has been ejected, remove the disc by hand and return it to its jewel
case.
Step 6.
If Power is off or tray will not eject correctly, insert a paper clip into the
manual eject hole, and push clip in until tray opens.
15
Advertisement
Table of Contents
