Quipped ); Ouch / J-Steel Dinette; (I F S O Equipped ) - Jayco SENECA 2010 Owner's Manual

B D (I
OOTH INETTE F
The dinette is designed to seat up to
adults. You can access the dinette be
storage by removing all the cushions and
lifting the bottom seat supports. If the dinette
bottom seat support is screwed shut, it is to
protect factory-installed equipment (do not
use that area for storage). To convert back to
a booth dinette, reverse the process.
The booth dinette can be converted into a
bed. To convert, remove all the cushio
the booth dinette. Lift the tabletop, remove the
detachable table legs and place the tabletop
on the ledges provided between the booth
dinette benches. Lay the seat back cushions
against the back of the booth dinette bench.
Lay the dinette seat bottom cushions in
between the seat back cushions. The area
where the cushions meet should be slightly
raised. Push the raised cushion ends down
gently. The cushions are designed to fit
snugly. Reverse this process when converting
back to the booth dinette.
C /J- D
OUCH STEEL
E )
QUIPPED
To store the b ed/so fa
travel, always properly raise the mini-blinds.
Be aware of moving parts at the end of the
bed/sofa when changing from one position to
the other. Keep all loose clothing, fingers, etc.
away from the ends.
1. Release the
couch/dinette in p lace against the wall.
2. Pull down on the metal support bar under
the couch/dinette. The legs will fold o
and into place. When pulled out from the
wall, the unit will be in the bed position.
3. To set up as a couch/dinette, stand at the
end of the couch/dinette seat. Pull up o
the top of the back rest and the front edge
of the seat to create a V-shape. Push the
seat toward the back rest to move the unit
into the set up position.
4. To move it back into the bed position, pull
up on the front edge of
the V-shape.
S E )
O QUIPPED
four
nch
ns from
(I S
INET TE F O
and pull o d wn bunk for
buckle holding the
the seat to create
5. Push down on the top of the back rest and
the front edge of the seat to lay it into the
bed position.
6. To store the couch/dinette against the
wall, it is necessary to have it in the bed
position.
Fig. 11.2 Couch/J-steel dinette
To complete the dinette set up, position the
table between the dinette seats.
J-Steel dinette and couch re
equipped)
The J-steel dinette
and couch
designed for removal
from the
create more room in
the cargo area.
Loosen the thumb
bolt securing
bracket to the ext
1. Lift up on the J-ste
from the bracket.
ut
2. Store and secure the J-steel dinette
in an appropriate place while traveling.
3. To set up, return
appropriate bracket.
n
4. Tighten the thumb bolt to secure t
dinette/couch in place.
The thumb bolt securing the J-steel
dinette/couch frames must always be
tightened when to preven
detaching from the bracket and damaging
the motorhome.
SECTION 11
CAMPING & OPERATING
moval (if so
are
wall to
Fig. 11.3 Thumb bolt
the
erior wall.
e l frame to remove it
the J-steel frame to the
t the J-steel from
/couch
he
79