Setup Menu - Panasonic WJ-RT416 Series Addendum Manual

If the firmware of this unit is Ver. 2.03 or later,
select "HD300" for "CONTROL" in 600 RECORDER of
SETUP MENU (OSD).
WJ-RT416 SERIES CONTROL (WJ-CU950/650 TERMINAL MODE)
The matrix switcher can control the following function of the
Digital Disk Recorder WJ-RT416 Series. The following is the
procedure for the WJ-RT416 Series SETUP MENU:
Notes:
• The following operating procedures are for the terminal
mode. If you are using a PS.Data system controller,
refer to page 6.
• When a Multiplexer board is installed in the matrix
switcher, you can neither connect nor control a WJ-
RT416 Series recorder. You need to remove the board
from the matrix switcher.
• Some parts of monitor displays described in this docu-
ment may differ from the actual parts.
I Displaying WJ-RT416 Series

SETUP MENU

To display the WJ-RT416 Series SETUP MENU, follow the
procedure below:
1. Confirm that the WJ-RT416 Series is correctly and
securely connected.
2. Select the desired monitor.
3. Activate the recorder mode.Then, the selected monitor
number, recorder number, and "/HD300" will appear on
the LCD.
Mon4 Cam--
4. Press the MENU button repeatedly until "System Setup"
appears on the LCD.
4
R4
/HD300
600 RECORDER
CONTROL
610 MASTER ---
620 SLAVE1 HD300
630 SLAVE2 HD300
640 SLAVE3 HD100
650 SLAVE4 OFF
--COMMUNICATION STATUS--
DATA BIT
PARITY BIT
STOP BIT
BAUD RATE
COMM PORT
System Setup
5On
Off
5. Press the F1 button.
System Setup
On Off
The WJ-RT416 Series SETUP MENU will appear on the
active monitor, and "B" mark will light up beside "On".
The following functions and buttons are valid in SETUP
MENU.
<Main unit>
JogDial clockwise: Increases a parameter.
JogDial counterclockwise: Decreases a parameter.
CAM (SET) button: Executes the selections and dis-
plays a submenu.
+ button: Increases a parameter.
– button: Decreases a parameter.
MON (ESC) button: Returns to the SETUP MENU or the
previous menu.
<3D joystick unit>
3D joystick upward (D): Moves the cursor up.
3D joystick downward (C): Moves the cursor down.
3D joystick to the left (A): Moves the cursor to the left.
3D joystick to the right (B): Moves the cursor to the
right.
ADR EXT IN
01 GENLOCK OFF
01 GENLOCK OFF
01
GENLOCK OFF
7bit
ODD
1bit
9600bps
SERIAL PORT
301
301