Power Linking; Fuse Replacement; Master/Slave Connection - Chauvet COLORado Batten 144 Tour Quick Reference Manual

COLORado™ Batten 144 Tour QRG
AC Power

Power Linking

Fuse
Replacement
DMX Linking
DMX Connection
Master/Slave
Connection
This product has an auto-ranging power supply that can work with an input
voltage range of 100~240 VAC, 50/60 Hz.
You can link up to three (3) COLORado™ Batten 144 Tour units to this
product at 120 VAC. Make sure to never exceed this number when linking
this fixture.
1) Disconnect the fixture from the power outlet.
2) With a Phillips #2 head screwdriver, unscrew the fuse holder cap from
its housing.
3) Remove the blown fuse and replace it with a good fuse of the same type
and rating.
4) Screw the fuse holder cap back in its place and reconnect power.
The COLORado™ Batten 144 Tour can work with a DMX controller when
linked using a regular DMX serial connection.
If you are not familiar with the DMX standard, please download the DMX
Primer document from www.chauvetlighting.com.
The COLORado™ Batten 144 Tour uses a regular DMX data connection for
its DMX personalities, TOUR, BLOCK1, BLOCK2, ARC1, ARC1+D,
ARC3, ARC3+D, ARC3+S, and HSV.
Download the COLORado™ Batten 144 Tour user manual and refer to the
Setup chapter to learn how to connect this fixture for DMX operation, and
the Operation chapter to learn in detail how to configure this fixture for
DMX operation.
The COLORado™ Batten 144 Tour uses the DMX data connection for its
Master/Slave mode.
Download the COLORado™ Batten 144 Tour user manual and refer to the
Setup chapter to learn how to connect this fixture for Master/Slave
operation, and the Operation chapter to learn in detail how to configure this
fixture for Master/Slave operation.
Page 4 of 12