Cycle Selection Chart; Canceling A Cycle - KitchenAid KUDI25CH Use & Care Manual

Undercounter dishwasher
Hide thumbs Also See for KUDI25CH:
Table of Contents

Advertisement

Available languages

Available languages

Cycle Selection Chart

Select the wash cycle and options desired. Or press
START to use the same cycle and options as the previous
cycle.
NOTE: If the last cycle you completed was a rinse cycle,
the dishwasher will run the last full wash cycle and options
that you selected when you press Start.
If the power is off or the door is open for an extended
period of time, the Start button memory will default to
the Normal cycle with heated drying.
If you do not run the dishwasher daily, close the door to
maintain memory.
A " " shows what steps are in each cycle. Your model
may have some or all of the cycles shown.
Temperatures indicate where extra heat is added.
Water usage is shown in U.S. gallons/liters.
Cycle time includes dry time. An asterisk ( * ) by the cycle
time indicates the cycle time might be longer depending
on the temperature of the water entering the dishwasher.
The cooler the water, the longer the cycle time. If the water
is already hot enough, the cycle time will be as shown.
Use this cycle for hard-
to-clean, heavily-soiled
pots, pans, casseroles,
and regular tableware.
Pre-
Rinse
Main
Rinse
Wash
Wash
135°F
140°F
(57°C)
(60°C)
Use this cycle for loads
with normal amounts of
food soil. (The energy-
usage label is based on
this cycle.)
Pre-
Rinse
Main
Purge
Wash
Wash
12
Use both
detergent
dispenser
sections.
Final
Dry
Time
Heated
(min)
Rinse
82*
140°F
(60°C)
Use both
detergent
dispenser
sections.
Final
Dry
Time
Heated
(min)
Rinse
75*
140°F
(60°C)
Use this cycle for china
and crystal. This cycle
uses a light wash and
gentle dry. During the
heated dry, the heating
element cycles on and
off.
Pre-
Rinse
Wash
Use this rinse cycle for
rinsing dishes, glasses,
and silverware that will
not be washed right
away.
Pre-
Rinse
Wash
A small amount of water is run through the pump to remove
soil particles between the main wash and final rinse.

Canceling a Cycle

Anytime during a cycle, press
Water
Usage
(gal/L)
CANCEL glows. The dishwasher pauses for 5 seconds and
8.6/32.7
starts a 2 minute drain (if needed). Let the dishwasher
drain completely. The light goes off when the dishwasher
finishes the drain.
To stop the drain
You can press Cancel again to stop the drain immediately.
Remember to drain the dishwasher before starting a new
cycle.
NOTE: A small amount of water remains in the dishwasher.
This is normal.
Water
Usage
(gal/L)
To clear the indicators
6.9/26.2
Press Cancel before starting the dishwasher to clear all
options and cycles.
Use
covered
detergent
dispenser
section.
Main
Rinse
Final
Dry
Wash
Heated
Rinse
130°F
cycled
(54°C)
Do not
use
detergent
with this
cycle.
Main
Rinse
Final
Dry
Wash
Heated
Rinse
Time
Water
(min)
Usage
(gal/L)
64*
6.5/24.5
Time
Water
(min)
Usage
(gal/L)
10
2.2/8.2

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kudm25sh

Table of Contents