Behringer X32 Reference Manual page 15

When the board starts up it will be in the exact state it was left in by the previous sound person.
Now that the board is powered on, you will need to load an appropriate scene as a starting point to work
from. Don't just assume that the board is ready to go as it will be configured according to how it was last
used. There are two options:
Option 1 - a basic service with no band, just a speaker and maybe some visuals.
Option 2 – adds a band to the basic service.
Scene management is accomplished using the SCENE section of the sound board, located on the far right (see
Figure 15 below).
Figure 15 - Scene section of the X32
On the far left of the board you will see two buttons labelled BAND and SERVICE, these will be referenced
later on in the manual.
Page 13