Configuring The Sound Board - Behringer X32 Reference Manual

3.0 CONFIGURING THE SOUND BOARD

The sound system is turned on by using the switch on the power bar, turning the switch on will turn on the
sound board, and the amplifiers.
Once the power is turned on, the board will boot up and when it gets to the home screen it is ready to use.
The first thing you want to do is confirm that the digital snake at the stage has connected and the connection
lights are showing green (see Figure 13 below) you should have a green square beside the line that says
A:S16 at the top of the screen.
Figure 13 - Digital Snake Connection Indication
If not – you need to reset the digital snake on stage – open the access panel on the right of the stage and
unplug the S16, wait for a few seconds and plug it back in (see Figure 14 below). Now check the status of the
connection lights on the sound board.
Figure 14 - Resetting the S16 Digital Snake
Page 12