Motherboard Installation; Tools Needed; Location Of Mounting Holes - Supermicro SuperO X10DRC-T4+ User Manual

2-3

Motherboard Installation

All motherboards have standard mounting holes to fit different types of chassis.
Make sure that the locations of all the mounting holes for both motherboard and
chassis match. Although a chassis may have both plastic and metal mounting fas-
teners, metal ones are highly recommended because they ground the motherboard
to the chassis. Make sure that the metal standoffs click in or are screwed in tightly.
Then use a screwdriver to secure the motherboard onto the motherboard tray.

Tools Needed

•
Phillips Screwdriver
•
Pan head screws (11 pieces)
•
Standoffs (11 pieces, if needed)

Location of Mounting Holes

There are eleven (11) mounting holes on this motherboard indicated by the arrows.
Caution: 1) To avoid damaging the motherboard and its components, please do
not use a force greater than 8 lb/inch on each mounting screw during motherboard
installation. 2) Some components are very close to the mounting holes. Please take
precautionary measures to prevent damage to these components when installing the
motherboard to the chassis.
BAR CODE
BIOS
MAC CODE
LICENSE
SAS CODE
SAN MAC
2-5
Chapter 2: Installation
X10DRC/i-LN4+(-T4+)
Rev. 1.01
IPMI CODE