Table of Contents
Advertisement
2.3 Motherboard Installation
All motherboards have standard mounting holes to fit different types of chassis. Make sure
that the locations of all the mounting holes for both the motherboard and the chassis match.
Although a chassis may have both plastic and metal mounting fasteners, metal ones are
highly recommended because they ground the motherboard to the chassis. Make sure that
the metal standoffs click in or are screwed in tightly.
Tools Needed
Phillips Screwdriver (1)
Location of Mounting Holes
Note 1: Do not use a force greater than 8 in-lbf (0.904 N-m) on each mounting screw
during motherboard installation. Exceeding this force may over-torque the screw, caus-
ing damage to the motherboard and screw.
Note 2: Some components are very close to the mounting holes. Please take precau-
tionary measures to avoid damaging these components when installing the mother-
board to the chassis.
Phillips Screws (9)
JUIDB1
UID_LED1
LE6
JVGA1
VGA
JPME1
UID
USB0/1
IPMI_LAN
(3.0)
SLOT1
BMC
BIOS
SATA 8~11
JTPM1
1
P1 AIOM PCIe 5.0 X16
JAIOM
LE1
BT1
SATA1
JPME2
BIOS
PCH
BAR CODE
LICENSE
IPMI CODE
SATA 0~7
X13DET-B
REV:1.01
CPU1
JBT1
SXB4
SXB3
SXB1
JPWR4
JPWR3
JPWR2
JPWR1
CPU2
51
Chapter 2: Installation
Standoffs (9) (Only if Needed)
SXB5
Advertisement
Table of Contents
