Hp Cables And Adapters - HP 650 Installation Manual

Hide thumbs Also See for 650:

Maintenance and service manual (111 pages)

Specification (28 pages)

Installation manual (20 pages)

100

101

102

103

104

105

106

107

108

109

110

111

112

113

114

115

116

117

118

119

120

121

122

123

124

125

126

127

128

129

130

Table of Contents

Cable and Connector on Router

RS-232 cable for a PC or terminal

connecting to router console port

RS-232 cable for a modem connecting

to router console port

* This cable or adapter is supplied with the router.

†

This part is not supplied with the router and is not available from HP; but it is generally available from most

suppliers of cable adapters.

‡

If this cable is used, the DTR signal must be on (high) in your terminal emulation program or in your terminal, and

the parameters "Enable DTR on Initialization" and "Ignore DCD" must be left at their default settings (refer to

"Configuration of Console Signals" on page A-3).

A-2

Cables and Adapters

This appendix provides:

Part numbers and pin-outs for the HP cable and the HP adapters

supplied with the router for connecting to a PC/terminal or modem.

Part numbers and pin-outs for alternate HP cables that can be used

for connecting to a PC/ terminal or modem.

The minimum pin-outs required if you will be making a cable or

purchasing a non-HP console cable, rather than using an HP cable.

For information about LAN and WAN cables, refer to the documentation

provided with the interface card to which they will be connected.