HP 650 Installation Manual page 63

Status Pwr/ Card
Fan/
Temp
Pwr
Engine:
Fan
Card:
Status Temp
Pwr
Engine:
Fan
Card:
Status
Pwr
Engine:
Fan
Card:
Status Temp
* Flashing.
Self- Port Net
test Fail
Port Failure
1. Verify that the node at the other end is up and running.
2. If this error persists, replace the cable and/or (if ThinLAN)
NetFail
its terminator.
(one port only)
3. If this error persists, and the port is an Ethernet/802.3
interface, replace the transceiver; if the port is a WAN
interface, verify that its configuration is correct.
4. Initiate the hot-swap self-test by doing either of the
following:
•
•
5. Wait a few seconds for the self-test to complete, then
check the Card and Self-test LEDs.
•
•
Note: if this error has occurred, the remaining ports on the
card can be used.
Interface Card Apparently Not Seated During Hot Swap
Verify that the interface card is seated properly in the router
slot.
Interface Card Self-Test Failure During Hot Swap
1. Note any error messages in the event log (which can be
displayed from the Main Menu).
NetFail
(all ports) 2. Switch the power off and on, then check the LEDs for
failures as indicated in table 3-1.
Interpreting LED Error Patterns
Diagnostic Tips
Hot-swap the card (do steps 1–5 and 8–11 of the
procedure "Replacing an Interface Card [System
Online]," page 3-21).
Use NCL's Disable command followed by the
Enable command (see the Operator's Reference ).
If the Card LED remains orange and the Self-test
LED remains green, the card is faulty.
If the Card LED turns green and the Self-test LED
turns off, call for service from your HP dealer or
service provider.
Troubleshooting
3-7