HP 650 Installation Manual page 71

[Return] again. If pressing [Return] four or five times does not display
either the copyright or Main menu screen, then ensure that you are
using the correct console cable. (Refer to "HP Cables and Adapters,"
page A-2.) If the cable is correct, then repeat this procedure for each
other baud rate available for your terminal until you find a rate that
gives you a successful connection. If you cannot establish a success-
ful connection, go on to "Reset the terminal" below.
Reset the terminal:
1. Switch the terminal or PC's power off and then on once.
2. Make sure the configuration for your terminal or emulation matches
the requirements listed under "Connect a console" (page 1-14).
3. Look for the line of text on your console that indicates waiting for
speed sensing; then press [Return] to display the copyright screen or
the Main menu screen. If neither of these screens appears, press
[Return] again several times.
Troubleshooting
Identifying a Bad Component
3-15