Paxar 676 User Manual page 28

C H A N G E
V A L U E : ± X X
C H A N G E
V A L U E : ± X X
C H A N G E
V A L U E : ± X X
H E A D
V A L U E : ± X X
28 • Control Panel Operation
S T R O B E
N E W
This screen is the first screen under PRINTHEAD SETUP screen. This screen
allows the user to adjust the strobe for station 1. The <YES / NO> buttons are used
to change the print value. The value is displayed in a positive/negative format. The
value ranges for X and Y can be from a -7 to a +7. Pressing ENTER will change the
CURRENT STROBE value to the NEW STROBE value.
Pressing the MODE/Down Arrow key will take the user to the next screen.
Pressing the EXIT/Up Arrow key will take the user back to the HOME screen.
S T R O B E
N E W
This screen follows strobe adjust for station 1. This screen allows the user to adjust
the strobe for station 2. The <YES / NO> buttons are used to change the print value.
The value is displayed in a positive/negative format. The value ranges for X and Y
can be from a -7 to a +7. Pressing ENTER will change the CURRENT STROBE
value to the NEW STROBE value.
Pressing the MODE/Down Arrow key will take the user to the next screen. Pressing
the EXIT/Up Arrow key will take the user back to the HOME screen.
S T R O B E
N E W
This screen follows strobe adjust for station 2. This screen allows the user to adjust
the strobe for station 3. The <YES / NO> buttons are used to change the print value.
The value is displayed in a positive/negative format. The value ranges for X and Y
can be from a -7 to a +7. Pressing ENTER will change the CURRENT STROBE
value to the NEW STROBE value.
Pressing the MODE/Down Arrow key will take the user to the next screen.
Pressing the EXIT/Up Arrow key will take the user back to the HOME screen.
C A T E G O R Y
N E W
This screen follows strobe adjust for station 3. The screen allows the user to enter
the head category for station 1. The <YES / NO> buttons are used to change the
head category value. The value ranges from 1 to 8. Pressing ENTER will change
the head category value to the new value. This value should be changed only if the
printhead is changed. See the section "PRINTHEAD REPLACEMENT" for
instructions on setting the head category.
Pressing the MODE/Down Arrow key will take the user to the next screen.
Pressing the EXIT/Up Arrow key will take the user back to the HOME screen.
S T A T I O N
V A L U E : ± Y Y
S T A T I O N
V A L U E : ± Y Y
S T A T I O N
V A L U E : ± Y Y
S T A T I O N
V A L U E : ± Y Y
1
2
3
1