Table of Contents
Advertisement
This section covers unpacking and inspection, installing LOOSE-SHIPPED PARTS, selecting location, installing
Unit, preparing for operation, and operation.
UNPACKING AND INSPECTION
(see Figure 7)
NOTE: The Unit was thoroughly inspected before leaving the factory and the carrier has accepted and
signed for it. Any damage or irregularities should be noted at time of delivery (or not later than 15 days
from date of delivery) and immediately reported to the delivering carrier. Request a written inspection
report from Claims Inspector to substantiate any necessary claim. File claim with the delivering carrier,
not with IMI Cornelius Inc.
1. After Unit has been unpacked, remove shipping tape and other packing material.
2. Remove Unit sides and back panels as instructed.
3. Remove shipping bolts that secure Unit to skid, then remove skid.
4. Unpack LOOSE-SHIPPED PARTS. Make sure all items are present and in good condition.
Item
No.
Part No.
1
178025100
Tapered Gasket, White
2
322859000
Spanner Wrench, Dispensing Valve
3
325216000
Cleaning Brush
4
311304000
Tapered Gasket, Black
5
317660000
Cup Rest
6
325282000
Thread Cutting Screw, Hex Hd.; No. 8 by 18 by 1/2-in. long
7
2738
Drip Tray Support, Left
8
2739
Drip Tray Support, Right
9
317659029
Drip Tray
10
326002000
Kit, Drip Tray Drain Hose
11
2899
Wrench, Rear Seal Housing
12
3810
Tool, Drive/Coupler Adjustment Gauge
13
324252000
Leveling Leg
14
3247
Spacer, White
15
3221
Front Access Panel
16
3108
Thread Cutting Screw, Phil Pan Hd; No. 10 by 32 by 1-in. long
* Numbers in parentheses are in reference to items in Figure 3.
IDENTIFICATION OF LOOSE-SHIPPED PARTS
1. TAPERED GASKETS, WHITE (item 1) are used to seal connections when connecting Unit product inlet
lines to product tanks and connecting Unit CO
INSTALLATION
Table 3. Loose-Shipped Parts
Name
inlet line to CO
2
7
source.
2
Qty.
4
1
1
1
1
2
1
1
1
1
1
1
4
2
1
2
2992
Advertisement
Table of Contents
Troubleshooting
