Table of Contents
Advertisement
8 Configure the settings relating to images [Image]
8 Configure the settings relating to images
[Image]
The JPEG and H.264 image settings and settings relating to image quality and RS485 can be configured on
this page.
The "Image" page has 3 tabs; the [JPEG/H.264] tab, the [Image/Position] tab and the [RS485] tab.
8.1 Configure the settings relating to the Picture
(Camera) mode/Video input [JPEG/H.264]
Click the [JPEG/H.264] tab on the "Image" page. (®page 21, page 23)
[Video input]
Select the camera video input from the following.
NTSC/PAL
•
Default: NTSC (P model), PAL (E model)
Note
•
When "NTSC" is selected for "Video input", the maximum frame rate is 30 fps. When "PAL" is selected,
the maximum frame rate is 25 fps.
•
When the [Set] button is pressed after changing the "Video input" setting, the settings are reset to the
default and the unit is rebooted. Note that the network settings will not be reset.
[Picture (Camera) mode]
Select the picture (camera) mode from the following.
VGA [4:3]/ VGA [16:9]/ D1
•
Default: VGA [4:3]
Note
•
When "Picture (Camera) mode" is changed to "D1" or the mode is changed from "D1" to another mode,
the unit will reboot automatically.
•
When "D1" is selected for "Picture (Camera) mode", some of the functions will not be available.
(®page 111)
•
Refer to our website (http://panasonic.net/pss/security/support/info.html) for further information about
the support of Panasonic network disk recorders when "D1" is selected for "Picture (Camera) mode".
•
Image/Position adjustment function is activated for the angle of view in "VGA [4:3]" even when "VGA
[16:9]" is selected for "Picture (Camera) mode". Because a part of the connected camera's setup menu
will not be displayed in this case, we recommend changing the "Picture (Camera) mode" setting to
"VGA [4:3]".
32
Operating Instructions
Advertisement
Table of Contents
