Paper Jams
Table 5.1
Paper Jam Messages (continued)
Message
Fin Fail H5-86
Power Off/On
Install
Staple Cartridge
Paper Jam
Clear Area A
Paper Jam
Clear Areas A,B
Paper Jam
Clear Area A,B,C
Paper Jam
Clear Area B
5-10
User Guide
Description/Corrective Action
Finisher stacker lower limit switch problem. Power off the printer. Then
power it back on again.
The finisher is out of staples. Remove the empty Staple Cartridge and install a
new one. Refer to "Adding Staples to the Finisher" (page 4-11).
A paper jam has occurred in Area A. Use one of the following procedures:
• "Clearing Area A (Without Duplex Module)" (page 5-14) or,
• "Clearing Area A (With Duplex Module)" (page 5-16).
A paper jam has occurred in Areas A and B. Use one of the following
procedures to clear Area A:
• "Clearing Area A (Without Duplex Module)" (page 5-14), or
• "Clearing Area A (With Duplex Module)" (page 5-16).
Then clear Area B (page 5-18).
A paper jam has occurred in Areas A, B, and C. First use one of the following
procedures to clear Area A:
• "Clearing Area A (Without Duplex Module)" (page 5-14), or
• "Clearing Area A (With Duplex Module)" (page 5-16).
Then Clear Areas B and C (page 5-18).
A paper jam has occurred in Area B. Clear Area B (page 5-18).
Table 5.1 Page 4 of 7