Maytag LAT2300 Service Manual page 61

For Delicates, washable woolens, or
loosely woven items, turn the control
knob to 8 minutes for Normal cycle and
to 5 minutes for a Light cycle.
The Quick Cycle reduces the cycle time
by using a 6 minute wash and a shorter
first spin and rinse. Total cycle time is
approximately 16 minutes plus fill
times. To select, turn the control knob
to start. (Recommended for lightly
soiled items).
NOTE: The washer is automatically
programmed to assure proper agitation
and spinning for each load type.
REGULAR FABRIC cycles and the
QUICK CYCLE will provide a fast
wash/spin speed. PERMANENT PRESS
will have a fast wash/spin speed along
with a cool-down rinse. DELICATE
cycles will have a gently wash and slow
final spin speed.
Start the Washer
Pull out the cycle control knob to start
the washer. It will fill to the selected
water level with the selected wash
water temperature. After filling, it will
agitate for the selected number of
minutes.
16001145
The washer will pause briefly
throughout each cycle. These pauses
are normal.
This washer is designed so that it will
not agitate or spin when the lid is open.
It will, however, fill with the lid open so
water is available for pretreating stains
or diluting fabric softener. However,
when returning saved water the lid
must be closed. Should the lid be
opened during a cycle, the washer will
stop; when the lid is closed and the
control knob is pulled out, the washer
will resume its cycle at the point it was
interrupted.
NOTE: If an unbalanced load occurs
during the spin, the washer will auto-
matically stop. If this happens, push in
the control knob, wait for the tub to stop
spinning, open the lid, redistribute the
load, close the lid and pullout the
control knob.
Indicator Light
The ON light stays lit throughout the
entire cycle indicating the washer is
operating.
SECTION 2. CONTROLS
2-29