Maytag LAT2300 Service Manual page 112

12. Grasp the drive pulley and slowly
pull the center shaft out. Only a
small amount of force will be
needed to remove the shaft. Be
careful not to damage the lip seal at
the bottom of the transmission.
13. Pull the agitator shaft out through
the tub. Remove the
"a"
ring from
shaft.
Note: You may have to pull hard on
this as the oil in the torque block
forms a suction.
14. With the agitator and drive shafts
removed, simply lift out the fol-
lowing parts: lower collar and
pinion gear, followed by the clutch
plate and splined washer which are
both located under the pinion gear.
15. The torque block and yoke can now
be removed as can the bevel gear.
Underneath the bevel gear is a
spacer washer. Remove it.
16. At this point, all components to be
reassembled should be cleaned.
Also, clean any silastic from the
transmission housing and cover
before reassembling.
REASSEMBLY
1. Install spacer washer followed by
the bevel gear on the center stud
pin. Apply thin film of oil on stud
before installing gear.
2. Place pivot stud of torque block yoke
into the hole in the bevel gear. Point
the unsplined portion of the torque
•
16001145 SECTION 3. WASHER - SERVICE PROCEDURES
3-44
©1994 Maytag Corporation