Maytag LAT2300 Service Manual page 20

15. Check unit again with a level. Be
sure that machine does not rock.
16. Connect groundwire to back of unit
by using wire supplied (found in the
accessory package in washer tub).
Secure other end of ground wire
with clamp (also in accessory
package) to COLD water pipe.
16001145
17. Plug power cord into properly
grounded electrical outlet.
18. Move washer into position. Remove
tape from lid. Open lid to remove
tub block.
19. Check operation using check list:
Check List:
• Tub Block, accessory package and
instructions have been removed from
tub.
SECTION 1. GENERAL INFORMATION
1-12
©1994 Maytag Corporation