Maytag LAT2300 Service Manual page 44

LAT8824 • LAT8804
Features may vary according to model
Select Options
Energy Saver Water Temperature
Extra Rinse
Additional deep rinse is automatically
added to Regular Fabric loads by using
the EXTRA RINSE option. Press the
EXTRA RINSE switch to the "ON" posi-
tion before the cycle begins. The
washer will add a second rinse and
spin to the cycle. The water temper-
ature will be the same as the initial
rinse.
Wash/Spin Speed
By pressing the appropriate button, the
wash and spin speeds can be adjusted
to fit the washing requirements of the
load.
• REGULAR/FAST
• GENTLE/SLOW
Select Water Level
Move the infinite slide lever up or down
to Extra Small, Small, Medium, Large,
Extra Large, or any point in between. If
more water is needed once the fill is
16001145
complete, move the lever all the way up
to Reset, then move it to the desired
setting.
Remember, for best washing results,
clothes must circulate freely. If too little
water is used, it may result in poor
washing action, linting or wear on
fabrics. Use the following as a guide to
select the proper water level:
• Extra Large - Use this setting when
the tub is 3/4 to full of clothes.
• Large - Use this setting when the tub
is 1/2 to 3/4 full of clothes.
• Medium - Use this setting when the
tub is 1/3 to 1/2 full of clothes.
• Small - Use this setting when the tub
is 1/4 to 1/3 full of clothes.
• Extra Small - Less than 1/4 full of
clothes.
NOTE: When laundering permanent
press or delicately constructed items,
washable woolens or loosely knit items,
never use less than the "Medium"
setting. This will minimize shrinkage,
wrinkling and pulling of seams.
SECTION 2. CONTROLS
2-12
©1994 Maytag Corporation