Table of Contents
Advertisement
10. Press down on the barcode label and the indicated corner to make sure the
11. Remove the protective cover, tape, or label from the surface of the
12. Lift the microprocessor-release lever to the fully open position (90°).
34
IntelliStation A Pro Type 6224: Installation Guide
Alignment
holes
Press points
Alignment
pins
System
board
6. Remove the six indicated screws from the system board.
7. Position the alignment holes in the microprocessor board over the guide pins
on the system board; then, lower the microprocessor board onto the guide
pins.
8. Make sure the connectors on the underside of the microprocessor board line
up with the second-microprocessor connectors on the system board.
9. Tighten the four screws on the fan-sink socket; then, tighten the two screws on
the corners of the microprocessor board to secure the microprocessor board to
the system board.
microprocessor board is firmly seated in the connectors on the system board.
microprocessor socket, if any is present.
Attention:
You must make sure that the locking lever on the microprocessor
socket is in the fully open position before you insert the microprocessor in the
socket. Failure to do so might result in permanent damage to the
microprocessor, microprocessor socket, and system board.
Option screws
(captive)
Microrpocessor
board
Short
screws
Second-microprocessor
connectors
Lever open
Advertisement
Table of Contents
