Replacing Cr Tape Wire - MUTOH ValueJet VJ-1604 Maintenance Manual

VJ-1604 Maintenance Manual
4.7.8

Replacing CR Tape Wire

CAUTION
• When replacing the board or connecting and removing FFC, first remove the power plug
and leave it for a while. Overcurrent may occur and damage the board.
• When connecting and removing the FFC type cables to/from the CR board assembly
connectors, always pull or push the cables perpendicularly to the connector.
Pulling or pushing them slantwise may damage/short/break the terminals in the
connectors, resulting in a breakdown of the on-board devices.
• The cables can be connected or removed up to 5 times.
1. Remove the CR cover.
"4.8.2 Removing CR Board Cover" p.4-106
2. Remove the steel bearer.
"4.7.7 Replacing Steel Bearer" p.4-97
3. Remove the board box cover 64.
"4.4.1 Opening Board Box 64" p.4-40
4. Detach CR-FFC (3 pieces) from the CR board assembly (J201 - J203).]
5. Detach CR-FFC (3 pieces) from the MAIN board assembly (J9 - J11).
6. Remove the screws (2 pieces) that retain the FFC guide (1 piece).
7. Remove the FFC guide.
8. Remove the FT guide material.
No.
3
1
1 FFC guide
2 Screws that retain the FFC guide
(pan-head screw with spring washer and flat washer M3
3 FT guide
Part name
4-99
4 Parts Replacement
2
3
×
6)
Rev.-00