Table of Contents
Advertisement
12 Setup
2.5 Inserting batteries in the remote control
2.6 Switching on for the first time
2.6.1 Powering on and checking picture
Open the battery compartment by removing the lid, and then
insert the batteries observing the polarity, which is marked on
the base of the battery compartment.
If the digital receiver no longer reacts properly to remote con-
trol commands, the batteries may be flat. Be sure to remove
used batteries. The manufacturer accepts no liability for the
damage resulting from leaking batteries.
NOTE
Batteries, including those which contain no heavy metals, may
not be disposed with other household wastes. Please dispose
of used batteries in an environmentally sound manner. Find
out the legal regulations which apply in your area.
Now that you have your digital receiver connected, you should
plug it into a mains socket. Ensure that your television set is
turned on and on the correct AV channel, so that you will be
able to see the display from the digital receiver.
Press the
button in top left corner on the remote control.
After about 10 seconds you may see a picture displaying a
menu. If you do not see a picture, try pressing the
button on the remote control. If after several tries you still get
no picture, check that the television is set to the correct input.
If the picture is good, you can skip to §
available television and radio services. Otherwise, you may
need to temporarily connect the composite video connector
(VIDEO) to your television set so that you can see the on-screen
menus in order to configure the video settings.
V.Format
4.1
to search for the
Advertisement
Table of Contents
