Connecting To Your Video Cassette Recorder; Switching On For The First Time; Inserting Batteries In The Remote Control - Topfield TF 4400 PVRt User Manual

14 Setup

2.4.3 Connecting to your video cassette recorder

2.5 Switching on for the first time

2.5.1 Inserting batteries in the remote control

The digital receiver can also output video to another appliance
such as a video cassette recorder through an auxiliary SCART
connector.
Now that you have your digital receiver connected, you should
plug it into a mains socket. Ensure that your television set is
turned on, so that you will be able to see the display from the
digital receiver.
To insert the batteries, open the battery compartment by remov-
ing the lid, and then insert the batteries observing the polarity,
which is marked on the base of the battery compartment.
In this case, you will need to connect a ca-
ble from the RF OUT socket to the antenna
connector on your television. To ensure your
television can also pick up existing analogue
channels as well, you will need to connect
a cable from RF LOOP 2 OUT connector on
the back of the digital receiver to the RF IN
connector.
Tune your television set to channel 36 so that
you can see the output from the digital re-
ceiver.
You need to obtain a SCART cable to use the
auxiliary SCART connector. Plug one end of
the cable into the VCR socket on the digital re-
ceiver, and plug the other end into the match-
ing socket on your video cassette recorder or
suchlike.