Ignition Cycles - Harman P43 Owner's Manual

D. Ignition Cycles
1. At the beginning of each ignition cycle, it is normal to see
some smoke in the firebox. The smoke will stop once the
fire starts.
2. The distribution blower will automatically turn on after your
appliance has reached the set temperature.
This blower transfers heat from your appliance into the
room, and will continue to run in "constant burn" mode
at the set speed you have the control knob at. In "room
temp" mode however, the blower will turn on and off
in accordance to what temperature the room sensor is
reading. When the room sensor is satisfied the blower will
shut down until the room sensor sees a demand for heat.
3. Occasionally the appliance may run out of fuel and shut
itself down. When this happens, the unit will need to be
turned to the off position and restarted.
If needed, follow the instructions in Section A "Starting
Your First Fire".
13 Harman® • P-Series Owner's Manual_R1 • 03/14
!
wARNING
Fire Risk
Do NOT operate appliance:
• With appliance door open.
• Burnpot floor open.
• Cleaning slide plates open.
Do NOT store fuel:
• Closer than required clearances to combustibles
to appliance
• Within space required for loading or ash
removal.
3-90-436168c