General Operating Information - Harman P43 Owner's Manual

E. General Operating Information
1. Room Sensor Calls For Heat
The appliance is like most modern furnaces; when the room
sensor calls for heat, your appliance will automatically light
and deliver heat.
When the room is up to temperature and the room sensor is
satisfied, the appliance will shut down.
2. Heat Output Controls
The appliance will turn on and off as the room sensor
demands. When the room sensor calls for heat, the appliance
will always start up on High. After burning approximately 7-10
minutes, the appliance will then burn at the rate at which it
was originally set. If the appliance is set at one of the lower
settings, it will run quieter but take longer to heat up an area
than if it were set at a higher burn rate.
Regardless of the burn rate, when the area is warm enough
to satisfy the room sensor, the appliance will shut off.
Figure 3.1
11
E. Before Your First Fire
1. Make sure your appliance has been properly installed and
2. Double check that the ash pan and firebox are empty!
3. Close the front door.
Harman® • P-Series Owner's Manual_R1 • 03/14
!
wARNING
Fire Hazard.
Keep combustible materials, gasoline
and other flammable vapors and liquids
clear of appliance.
• Do NOT store flammable materials in the appliance's vicinity.
• NEVER USE GASOLINE, GASOLINE-TYPE LANTERN
FUEL, KEROSENE, CHARCOAL LIGHTER FLUID, OR
SIMILAR LIQUIDS TO START OR "FRESHEN UP" A FIRE
IN THIS HEATER. KEEP ALL SUCH LIQUIDS WELL AWAY
FROM THE HEATER WHILE IT IS IN USE.
• DO NOT BURN GARBAGE OR FLAMMABLE FLUIDS SUCH
AS GASOLINE, NAPHTHA OR ENGINE OIL.
• DO NOT USE CHEMICALS OF FLUIDS TO START THE
FIRE.
• Combustible materials may ignite.
that all safety requirements have been met. Pay particular
attention to the fire protection and venting instructions.
3-90-436168c