Headset Microphone Type Selection (Dip Switch 4); Balanced/Unbalance Switch (Sw-1) - Telex Audiocom WM1000 User Instructions

Configuration Switch Settings
TABLE 1.
SWITCH
NUMBER
1
2
3
4
5
6
7
8

Headset Microphone Type Selection (DIP Switch 4)

If the headset specifications indicate the microphone type is balanced, or if you are
unsure, leave this switch in the off (default) position. If the specifications indicate an
unbalanced microphone, set DIP switch to on.

Balanced/Unbalance Switch (SW-1)

This switch is set at the factory to the balanced (BAL) position for use with
Audiocom intercom channels. Set the switch to the unbalanced (UNBAL) position for
use with Clear-Com intercom systems. Be sure and use the appropriate connection
information based on how you have this switch set.
DESCRIPTION
Mic Kill Receive
Call Signal Method
Incoming Call Beep
Microphone Type
Speaker Beep for
Incoming Call
Not Used
Not Used
Not Used
SETTINGS
OPEN=OFF, CLOSED =ON
Closed: Disabled, No Mic Kill
Open: Enabled, Mic Kill Active
Closed: DC (SW1 set to UNBAL)
Open: Audiocom (SW1 set to BAL)
Closed: Disabled
Open: Enabled
Closed: Unbalanced
Open: Balanced
Closed: Enabled (DIP switch 3 must
be set to open)
Open: Disabled
Not Defined
Not Defined
Not Defined
7
DEFAULT
SETTINGS
Open
Open
Open
Open
Open
Open
Open
Open