Table of Contents
Advertisement
M38BV-ST-I
WARNING:
A. This appliance is equipped with an ignition
system that lights the pilot burner automatically.
Do not attempt to light the pilot by hand.
B. BEFORE LIGHTING smell all around the
appliance area for gas. Be sure to smell next to
the floor because some gas is heavier than air
and will settle on the floor.
What To Do If You Smell Gas:
n
Do not try to light any appliance.
n
Do not touch any electrical switch; do not use
any phone in your building.
n
Immediately call your gas supplier from a
neighbour's phone. Follow the gas supplier's
instructions.
1. STOP! Read the safety information above on
this label.
2. Remove lower trims.
3. Turn switch on the gas control to OFF".
4. Wait 5 minutes to clear out any gas. If you smell
gas, STOP! Follow "B" in the safety information
above on this label. If you don't smell gas, go to
the next step.
5. Turn switch on the gas control to "ON". NOTE:
This unit is equipped with an ignition system that
lights the pilot burner automatically. Do not
attempt to light the pilot by hand.
6. Turn on wall switch.
7. Replace lower trim.
1. Turn off remote switch.
2. Remove lower trim.
XG0400 05/00
Operation - Model M38BV-ST-I
with Honeywell Intermittent Pilot
For Your Safety - READ BEFORE LIGHTING:
If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury or loss of life.
Lighting Instructions:
To Turn Off Gas To Appliance:
M38BV-ST B-Vented Fireplace
n
If you cannot reach your gas supplier, call the
Fire Department.
C. Use only your hand to push in or turn the gas
control knob. Never use tools. If the knob will
not push in or turn by hand, don't try to repair it,
call a qualified service technician. Force or
attempt to repair may result in a fire or
explosion.
D. Do not use this appliance if any part has been
under water. Immediately call a qualified service
technician to inspect the appliance and to
replace any part of the control system, and any
gas control which has been under water.
8. If the fireplace does not operate, follow the
instructions "To Turn Off Gas To Appliance" and
call your service technician or gas supplier.
Gas
Inlet
Gas Control Switch
Shown in "On" Position
3. Turn the switch on the gas control to "Off".
4. Replace trim.
Page 9
Advertisement
Table of Contents
