Lighting Instructions; To Turn Off Gas To Appliance - Montigo L38DF Installation Operation & Maintenance

f i r e f e a t u r e
Operation - Model L-Series DF-I
L-Series DF-I
For Your Safety - READ BEFORE LIGHTING:
WARNING:
A. This appliance is equipped with an ignition system that
lights the pilot burner automatically. Do not attempt to
light the pilot by hand.
B. BEFORE LIGHTING smell all around the appliance area for
gas. Be sure to smell next to the floor because some gas
is heavier than air and will settle on the floor.
What To Do If You Smell Gas:
Do not try to light any appliance.

Do not touch any electrical switch; do not use any phone

in your building.
Immediately call your gas supplier from a neighbour's

phone. Follow the gas supplier's instructions.
1. STOP! Read the safety information above on this label.
2. Flip down the lower trims.
3. Turn switch on the gas control to OFF".
4. Wait 5 minutes to clear out any gas. If you smell gas,
STOP! Follow "B" in the safety information above on this
label. If you don't smell gas, go to the next step.
5. Turn switch on the gas control to "ON". NOTE: This unit is
equipped with an ignition system that lights the pilot burner
automatically. Do not attempt to light the pilot by hand.
6. Turn on wall switch.
7. Flip up the lower trim.
1. Turn off remote switch.
2. Flip down the lower trim.
Part No. XG0180
with Honeywell Electronic Ignition
If you do not follow these instructions exactly, a fire or explosion may
result causing property damage, personal injury or loss of life.

Lighting Instructions:

To Turn Off Gas To Appliance:

If you cannot reach your gas supplier, call the Fire

Department.
C. Use only your hand to push in or turn the gas control knob.
Never use tools. If the knob will not push in or turn by
hand, don't try to repair it, call a qualified service technician.
Force or attempt to repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect
the appliance and to replace any part of the control system,
and any gas control which has been under water.
8. If the fireplace does not operate, follow the instructions "To
Turn Off Gas To Appliance" and call your service technician
or gas supplier.
Gas
Inlet
Gas Control Switch
Shown in "On" Position
3. Turn the switch on the gas control to "Off".
4. Flip up the trim.
L-Series DF Gas Fireplace
Page 1