Table of Contents
Advertisement
M38BV-ST B-Vented Fireplace
M38BV-ST
WARNING:
A.
This appliance has a pilot which must be lighted by
hand. When lighting the pilot, follow these instructions
exactly.
B. BEFORE LIGHTING smell all around the appliance
area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will settle
on the floor.
What To Do If You Smell Gas:
n
Do not try to light any appliance.
n
Do not touch any electrical switch; do not use any
phone in your building.
n
Immediately call your gas supplier from a
neighbour's phone. Follow the gas supplier's
instructions.
1.
STOP! Read the safety information above on this
label.
2. Remove lower trims.
3. Push in gas control knob and turn clockwise
"OFF."
4. Wait five (5) minutes to clear out any gas. Smell for
gas, including near the floor. If you then smell gas,
STOP! Follow "B" in the safety information above on
this label. If you don't smell gas, go to the next step.
5. Locate pilot burner (See illustration at right.) and follow
steps below.
Gas Control Knob
(Shown in "Pilot" postion.)
1. Turn off remote switch.
2. Remove lower trim.
Page 8
Operation - Model M38BV-ST
with Continuous Pilot
For Your Safety - READ BEFORE LIGHTING:
If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury or loss of life.
Lighting Instructions:
To Turn Off Gas To Appliance:
n
If you cannot reach your gas supplier, call the Fire
Department.
C. Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in or
turn by hand, don't try to repair it, call a qualified
service technician. Force or attempt to repair may
result in a fire or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of the
control system, and any gas control which has been
under water.
6. Turn knob on gas control counterclockwise
"PILOT."
7. Push in gas control knob completely and hold. Light
with Piezo Igniter button. Continue to hold the control
to
knob in for about (1) minute after the pilot is lit. Release
the knob and it will pop back up. Pilot should remain lit.
If it goes out repeat steps 3 through 8.
n
If knob does not pop up when released. Stop and
immediately call your
service technician or gas
supplier.
n
If the pilot will not stay lit
after several tries, turn the
gas control knob to "OFF"
and call your service
technician or gas supplier.
8. Push in gas control knob and turn counterclockwise
to "ON."
9. Replace lower trim.
10.Turn on remote switch to ignite fire.
3. Push in gas control knob slightly and turn
clockwise to "Off". Do not force.
4. Replace trim.
to
XG0400 05/00
Advertisement
Table of Contents
