Figure 3
Correct
Correct
Figure 4
REROUTING
1. Reroute the ignition switch lead wire correctly (Figure 3 and Figure 4). The ignition switch
lead wire should not be covered by the other wire harnesses.
2. Turn the handlebars back and forth to verify that the steering operates smoothly and the
wiring harness does not become kinked or pinched.
3. Proceed to PUNCH MARK AT VIN on page 8.
Correct
90
0
- 5/12-
Correct Routing
The ignition switch
lead wire is routed in
front of the right
switch lead wire.
Correct Gray Tape
90
0
Gray tape is visible on
both sides of clamp.
Front side
Location